Product Description
The Starlink 3rd Generation Dishy works best above the roof of the RV. This Flag Pole Buddy Starlink Mounting Kit allows you to install the dish above the RV safely without climbing the ladder. With this patented mounting system, the pole angles in from ground level and secures the pole in two places. Unlike telescoping poles, this 2" diameter aluminum sectional pole won't collapse, won't lock up, and allows the user to create a custom height. This system allows for two methods of cable management. It comes in 4' sections for storage. The pole sections with a combination of a swaged diameters and dual spring buttons create a sturdy pole for your dish. The adapter allows the Starlink cable to run either on the outside or inside of the pole. It's NOT recommended to running the cable inside the pole, as it may put too much tension on the cable connector. The patented "two" mount holding system distributes the wind loading stresses throughout all ladder supports, keeping the user out of harm's way by ground level installation. The Starlink Kit uses lightweight aluminum poles, fiberglass-filled nylon, and stainless steel hardware so they won't rust.· Kit gets your Starlink Dishy over 13' in the air· Modular system for easy installation and break down· Jumbo pole bag for storing the sectional pole and accessories· Made using lightweight aluminum, fiberglass-filled nylon, and stainless steel· Fits the Flag Pole Buddy 2" mountsNOTE: Starlink Dishy not included. Kit Comes With:(1) Starlink Generation 3 Adapter(2) 4' Aluminum Pole Sections (20-ga. 2" dia. with spring buttons)(3) Cable Clamps(1) Jumbo Pole Bag(1) Pole Strap (for extra support in high winds and less vibration/noise)(1) 2.0" dia. Upper Pole Holder (Twist)(1) 2.0" dia. Lower Pole Holder (Cup)(2) Mounts (on 1.00" dia. RV Ladder or Flat Surface)(2) Mount Caps (can be replaced for larger dia. ladders)(10) Nuts (nylock)(8) Bolts (stainless steel, allen screws)(1) Plastic Thumb Screw (for directional pole control)(1) Nut Driver(1) Allen Wrench Two-mount holding system distributes wind loading stress throughout ladder support Made using lightweight aluminum poles, fiberglass-filled nylon, and stainless steel hardware Jumbo Pole Bag for easily storing the sectional pole and accessories | Flag Pole Buddy Gen 3 Starlink Mounting Kit
